Peugeot 208 Key Replacement
Peugeot 208 key replacement is best left to experienced auto locksmiths who have the appropriate equipment and know-how. They will be able to make and program new keys faster than a dealership would and at a lesser cost.
If the key fob stopped locking or unlocking your doors it is likely due to a dead coin battery. There are other reasons that the key might be malfunctioning.
Dead Coin Battery
A dead coin battery can prevent your Peugeot 208 from locking or unlocking and will not allow you to start the engine. If this is the case, you'll need to apply the backup starting technique that is described in the owner's manual of your vehicle.
The spark plugs may also be worn out. The spark plugs are responsible to ignite the fuel that powers the engine. However, they have a limited life span. They'll eventually break down if they're not used enough.
Fortunately, there's an easy solution for this issue. Check the voltage of the battery using a multimeter. If peugeot car key replacement G28CarKeys is less than 11,5 volts, it's time to replace it. It is also essential to clean the contacts of the battery in the event that it is damaged by corrosion. This can be done by lifting the rubber covers covering the two terminals of the battery and using a wire brush to remove any corroded components of the battery. Then, you should connect the cables that connect the positive and negative poles.
Water Damage
If your 208 doesn't start and the battery has not been replaced, you must inspect the spark plugs. You might find that they are simply too dirty and they don't spark. The spark plugs can be cleaned in a workshop.
Peugeot automobiles use a transponder style key that integrates with the car's immobiliser system. This ensures only the correct key is able to turn the engine. If the chip in the Peugeot key is damaged, it will not transmit the proper signal to the vehicle.
Water damage is a typical cause of this problem. This is particularly common in colder climates. the vehicle may have been exposed to snow or rain. If this is the case, get in touch with a reputable locksmith who will have all of the tools and equipment required to change the key's programming. They will also have the latest technology and machinery needed to create the Peugeot smart key. The process shouldn't take more than 15 minutes.
Contacts for the battery that are defective
Peugeot changed from the carbon-encased transponder chips to a new type of chip that incorporates electronic components on circuit boards. This new technology works great when it's brand new, but as time passes, the circuit boards start to wear out and stop functioning correctly.
This can prevent the immobiliser from triggering so that your vehicle will not start. Contact a Peugeot specialist or a locksmith, if this is the case.
Another common issue is when the battery for the key fob starts to die, this causes the blade of the key to stop from entering the lock. A car locksmith will replace the battery and then cut a new blade for you. This is a simple solution.
Faulty Receiver Module
If your Peugeot key fob has stopped working after dropping it on the ground, being exposed to a sudden rain or accidently washing it the wrong way, it could be due to a malfunctioning receiver module. The receiver is responsible for transmitting radio frequency signals to an on-board computer, which controls the central locking system in your Peugeot vehicle.
Rubber seals on the key fob keep water from getting to the electronic chip. The chip can be damaged by water if it is exposed to water for a long period of. The high salt content in the pool or ocean water can cause damage to the key fob, especially if it is submerged.
If your Peugeot spare key fob doesn't work, you'll need to have the module replaced. This is only done by an expert auto locksmith or Peugeot specialist. In contrast to other vehicles, Peugeot keys are protected by an unique immobilizer system that requires the correct code to start the engine. This is why you must choose a reputable Peugeot locksmith to take on the job of designing and programming an appropriate replacement.
Computer malfunctioning on-board
The on-board computer in your Peugeot is responsible for a variety of systems in your car, including power windows and airbags. When something goes wrong in these systems, it will usually display a code that indicates the issue. This code will be stored within the system until the issue is resolved. This can often mean that the on-board computers to be replaced.
The most typical reason for the warning light for the airbag to illuminate is corrosion or loose connections within the sensor. This could be due to wear and tear, age or exposure to salt and moisture. This issue needs to be addressed as soon you can, since an airbag that is malfunctioning could pose danger in the event of an accident.
If you find a card not found error on your Peugeot key fob, the battery in the key fob might be dead or weak. This will stop the key fob sending a signal to disable the immobilizer in your vehicle. You can test this by pressing the unlock button on the key fob, then trying to start your vehicle. If it doesn't work it is because the battery of the key must be replaced.